Finite Element Analysis of a PTO Shaft Used in an Agricultural Tractor

Authors:

H. Kursat Celik¹*, Recep CINAR², Gokhan KUNT¹, Allan E.W. RENNIE³, Mehmet UCAR⁴ and Ibrahim AKINCI¹

DOI: 10.23880/eoij-16000147

Volume 2, Issue 3

Abstract

This study describes a finite element method (FEM) based deformation simulation procedure for a power take off (PTO) shaft in an agricultural tractor. The agricultural tractor is a mobile power source in agricultural fields. The Agricultural tractor transmits power to the working implement through several systems independently. Most especially, rotary elements used in agricultural machinery take the required power and movement from the tractor take off (PTO) shaft. During this operation, the PTO shaft experiences a high dynamic loading condition such as excessive instant (impact) loading. This may cause an undesired failure case for the PTO shaft. In order to prevent such undesired failures, loading condition and stress distribution on the component should be described properly; however, an accurate description of the structural stress distribution on the shaft becomes an important problem. In this content, a case study was carried out on a failed PTO shaft, as described in this paper. The aim of this case study is to exhibit the stress distribution on the PTO shaft through finite element analysis under a torsional loading case which may be considered as the main cause of the failure. Visual outputs from the simulation results revealed a better understanding of the failure zone on the shaft. The maximum equivalent stress magnitude obtained from the simulation was 632.08 [MPa] (which was lower than the fracture point) on the shaft under maximum PTO torque, however, it was concluded that the main reason for the failure was excessive shock torsional loading. This work contributes to further research into usage of numerical method based deformation simulation studies for the transmission elements used in agricultural tractors/machinery.

Keywords:

Design of Agricultural Machinery; Finite Element Analysis; Stress Analysis; Engineering Simulation; PTO Shaft Failure; Shock Loading

View PDF